Aquverse A3000 Installationsanleitung PDF herunterladen (Seite 2)

1. Note that your cooler is built with a no spill kit (see figure E below). This unit is designed to be used with a bottle that has a

cap made to be punctured by our probe (see figure F below). The bottle cap (see figure G below) can be taken off if you also

remove the no spill kit completely (see figure H below)

Figure E Figure F Figure G Figure H

2. If cooler is not functioning make sure you are using a working outlet by testing it with a lamp

What To Do If:

1. Cooler Is Not Dispensing Water

a. Make sure water bottle is full

b. Make sure the water bottle is being properly pierced by the probe in the baffle

c. Confirm that cooler is not frozen by:

1. Removing baffle (see above instructions under Parts Removal section 3),

d. Check water bottle to determine if cap is jammed and not dispensing water (see figure I below)

Figure I

e. Check faucets to determine if water is able to flow through when in on position (see figure J and K below)

Figure J Figure K

2. Cooler Is Not Dispensing Chilled Water

a. Check that cold water thermostat is not turned to the off position (see figure L below)

Figure L

1 2 3 4

Keine Kommentare

Aquverse A3000 Installationsanleitung Seite 2